Stainless Steel Spring Wire for Polylock

Stainless Steel Spring Wire used to secure the polyethylene film into the Polylock of the caterpillar tunnel or greenhouse structure.

Polylock Assembly instructions : 

• Distribute the polyethylene evenly over the polylock.
• Insert the end of the stainless steel wire into the end of the polylock to secure the polyethylene film in place.
• Insert the stainless steel wire into the polylock, bending one section at a time.
• Add the next wire in the polylock, overlaping it 2 to 3 inches with the first wire. Repeat this step for each addition of wire.
• Make sure that the stainless steel wire does not protrude from the end of the polylock.

If the polyethylene has to end in the polylock, cut the polyethylene leaving a margin of about 3 inches.

*It is recommended to always wear safety glasses when installing the aluminum wires in the polylock.