Stainless Steel Spring Wire for Polylock

In stock
ITEM#
TC-BROCHE-AC-4

Stainless Steel Spring Wire used to secure the polyethylene film into the Polylock of the caterpillar tunnel or greenhouse structure.

*It is recommended to always wear safety glasses when installing the aluminum wires in the polylock.

Read More
USD$1.76
Size Description Caterpillar Tunnel Type
2 mm x 1,22 m
0,07'' x 4'
Stainless Steel Wire For entrance
For Longer Structure

Stainless Steel Spring Wire used to secure the polyethylene film into the Polylock of the caterpillar tunnel or greenhouse structure.

Polylock Assembly instructions : 

  • Distribute the polyethylene evenly over the polylock.
  • Insert the end of the stainless steel wire into the end of the polylock to secure the polyethylene film in place.
  • Insert the stainless steel wire into the polylock, bending one section at a time.
  • Add the next wire in the polylock, overlaping it 2 to 3 inches with the first wire. Repeat this step for each addition of wire.
  • Make sure that the stainless steel wire does not protrude from the end of the polylock.

If the polyethylene has to end in the polylock, cut the polyethylene leaving a margin of about 3 inches.

*It is recommended to always wear safety glasses when installing the aluminum wires in the polylock.

Write Your Own Review
You're reviewing:Stainless Steel Spring Wire for Polylock

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.