TeeJet Unique Nozzle Body for Rigid Pipes

In stock
IS TJQJ17560A3/4NYB-config
As low as USD$4.52
Product No. To Clamp On
IS TJQJ17560A3/4NYB 3/4'' pipe
(26,3–27,4 mm)
IS TJQJ17560A1NYB 1'' pipe
(33–34,1 mm)

The unique nozzle body for rigid pipes is used to create a customized, versatile spraying system. It is used for all spraying types: herbicides, fungicides, insecticides, etc., and it links the water supply pipe to the nozzle of your choice. It is installed on a ¾” or 1” aluminium, PVC or polyethylene pipe. The body is equipped with an anti-drip system and its maximum spray pressure is 300 psi (20 bar).


  • Pre-drill 9.5 mm (3/8”) holes in the water supply pipe at the desired locations.
  • Open the bracket by removing the screw, position it on the pipe and close it firmly.
  • Insert the nozzle and gasket inside the nut with a ¼ turn. If required, a filter can also be added (see the tips tab).
  • Install the nut with a ¼ turn on the nozzle body.


  • For installation on ¾” or 1” pipes.
  • Equipped with a ChemSaver® anti-drip system. A 10 psi (0.7 bar) pressure is required to operate the nozzle.
  • The standard membrane is made of EPDM with optional Viton.
  • Installation on a 9.5 mm hole drilled in the pipe with maximum spray pressure of 300 psi (20 bar).
  • The upper part of the bracket has a permanent hole for attachment on a flat surface.

Write Your Own Review
You're reviewing:TeeJet Unique Nozzle Body for Rigid Pipes

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.